Horner-apg QX351 OCS HEQX351C103 Manuel d'utilisateur télécharger pdf (Page 4)

MAN0893-02-EN Specifications / Installation

________________________________________________________________________________________________________________________________________

Feb 2, 2010 Page 4 of 5 #1039

4.2

Ethernet Port

Table 3 - Ethernet Port

Speeds 10 BaseT Ethernet (10-Mbps)

100 BaseTx Fast Ethernet (100-Mbps)

Modes Half or Full Duplex

Auto - Negotiation Both 10/100-Mbps and Half/Full Duplex

Connector Type Shielded RJ-45

Cable Type

(Recommended)

CAT5 (or better) UTP

Port Auto MDI/MDI-X

4.3 External DIP Switch settings

4.4 CAN Network Port and wiring 4.5 Power port and wiring

Table 2 - Ports and Functions

Functions Port 1 (MJ1) Port 2 (MJ2)

RS-232 



 





Hardware Handshaking 





Programming 





Ladder function controlled 



 





Serial Downloable

Protocols





 





RS 485 Full duplex







RS485 Half duplex 



 





NET 1 Port Pin Assignments

Pin Signal Signal Description Direction

1 V- CAN Ground -

2 CN_L CAN Data Low In/Out

3 SHLD Shield Ground -

4 CN_H CAN Data High In/Out

5 NC No Connect -

Primary Power Port Pins

Pin Signal Description

1 Ground Frame Ground

2 V- Input Power Supply Ground

3 V+ Input Power Supply Voltage

As seen when looking at the side of the QX351 unit:

The DIP Switches are used for

termination of the RS-

485 ports. The

QX351 is shipped un-terminated.

o terminate, select one of the DIP

Switches and configure it based

upon the option that is desired.

MJ1

Off

MJ2

SW1 –

ON enables MJ2 RS485 port termination (121 ohms)

OFF disables MJ2 RS485 port termination.

SW2 & SW3 –

ON places MJ2 RS485 port in half-duplex mode.

OFF places MJ2 RS485 port in full-duplex mode.

SW4 –

ON enables MJ1 RS485 port termination (121 ohms)

OFF disables MJ1 RS485 port termination.

CAN Connector

Use the CAN Connector when

using CsCAN network.

Torque rating 4.5 – 7 Lb-In

(0.50 – 0.78 N-m)

Power Connector

Power Up:

Connect to Earth Ground.

Apply 10 - 30 VDC.

Screen lights up.

Torque rating 4.5 – 7 Lb-In

(0.50 – 0.78 N-m)

1 2 3 4 5

Commentaires sur ces manuels

Pas de commentaire

Horner-apg QX351 OCS HEQX351C103 Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Capteurs Horner-apg QX351 OCS HEQX351C103