Horner-apg QX351 OCS HEQX351C103 Manuel d'utilisateur télécharger pdf (Page 37)

MAN0892-03-EN CH.9

February 25, 2010 Page 37 of 109 #1039

CHAPTER 9: SMARTSTACK I/O

Note: Because the configuration parameters are different for each SmartStack Module, refer to the data

sheet that is sent with the product and is specific to the selected module.

9.1 Configuration Procedures

Note: SmartStack Modules use Cscape Software for configuration. QX351 supports upto 2 smartstack

Modules.

1. From the Main Menu, select Controller | I/O Configure.

Note: The look of the screen varies depending upon the type of controller that appears.

2. First, ensure that the desired controller is selected.

In this case, a different controller than the one shown on the screen might be desired. It is

necessary to select the desired controller, which is the QX351. In this example configuration.

Continue with Step 2.

However, if you are satisfied with the controller selection, press a Base # tab. Go to Step 3

Figure 9.1: Main Configuration I/O Screen

Note: The Auto Config System button can be pressed prior to selecting the desired controller and I/O.

By pressing the button, the current configuration from the local ID is uploaded and any current settings

are overwritten. A dialog box appears and indicates that settings will be deleted from currently configured

models. If OK, press Yes. Then press OK.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 108 109

Pas de commentaire

Horner-apg QX351 OCS HEQX351C103 Manuel d'utilisateur Page 37