Horner-apg QX351 OCS HEQX351C103 Manuel d'utilisateur télécharger pdf (Page 84)

CH. 13 MAN0892-03-EN

February 25, 2010 Page 84 of 109 # 1039

If the controller is not communicating you may need to set the target ID of the controller in Cscape or on

the unit. The Target ID allows directing communications to a particular unit when multiple units are

connected via a CsCAN network. Units without CsCAN network ports respond to any network ID and do

not require the ID to be configured.

To check or change the ID on the QX351, press the UP and DOWN keys on the QX simultaneously to

enter the system menu. The first item in the menu is Set Network ID. Pressing Enter allows you to view

or modify the ID of the unit.

To change the Target ID of Cscape, use the Controller | Set Target Network ID dialog.

13.3.2 Communicating via On Board Ethernet Port

From Cscape go to Controller -> I/O Configure and do auto configuration for the connected controller,

Click on Config of Ethernet & go to Module Setup.

In Module configuration dialog go to IP Address field enter unused IP Address and configure unused

registers in Register field & then click OK. Screen shot for the same as follows:

Download the configuration to Controller. Connect LAN cable to the Controller in default LAN Port.

From Cscape go to Tools -> Editor Options -> Communication Port -> configure. Select Ethernet and

enter IP address which is configured in the file. Select mode as Nx/Qx Series mode from drop down list.

The controller should get connected to Cscape. If communications are successful, the target indicator

should show the mode of the controller Target: yy(R) as shown in the status section above.

13.4 Models supported

Cscape 8.7 and beyond supports all the options offered in the QX351. For the latest version of Cscape or

compatibility information,

contact Technical Support.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 108 109

Pas de commentaire

Horner-apg QX351 OCS HEQX351C103 Manuel d'utilisateur Page 84