Horner-apg QX651 OCS Manuel d'utilisateur télécharger pdf (Page 39)

MAN0798-04-EN CH. 8

August 20, 2009 Page 39 of 95 ECN # 979

8.6 Cscape Configuration for HSC / Frequency Measurement

8.6.1 Preliminary Configuration Procedures

Note: Although the example configuration in this section shows how to configure the QX551 BP43, it applies to any

QX controller using HSC.

1. From the main menu in Cscape, software, select Controller|I/O Configure.

2. Ensure that the desired controller is selected.

-In this case, a different controller is shown than the one that is desired. Continue with Step 2.

-If the controller you want to use is already selected, go to Step 3.

Note: The Auto Config System button can be pressed prior to selecting the desired controller and I/O. By pressing

the button, the current settings are deleted from the configuration within Cscape, and the I/O is then set to what is

physically contained in the attached controller. A dialog box appears and indicates that settings will be deleted from

the configuration within Cscape. If OK, press Yes. Then press OK.

Figure 8-2 – Main Configuration I/O Screen

Figure 8-3 – Selecting a Controller

Figure 8-4 – Screen with Desired Controller Selected

Tabs on the I/O Configuration Screen

The CPU Slots tab is already pressed in

this screen allowing you to view and

configure the controller and BP I/O

including HSC.

For I/O that is not

built-in to the QX:

Press the Main tab to configure and view

the I/O in the slots directly located on the

back of the QX.

Press any Base tab to configure and view

I/O in the slots located on a remote FOX

base. It is not

necessary to select bases in

a specific order.

2.a To change the controller, click on the

controller or the Config button next to it. The

Configure Controller screen appears .

2.b To select a different controller, click on the

Type list box and select the desired controller.

Press OK. Then, go to Step 3.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 94 95

Pas de commentaire

Horner-apg QX651 OCS Manuel d'utilisateur Page 39